Classic & Classic Smart Filter Replacement
AquaTru Classic & Connect - How to Change Your Filters
Replacement filters
Filter 1-2 | Pre/Carbon Filter
Filter 3 | Reverse Osmosis Filter
Filter 4 | VOC Carbon Filter or VOC Carbon Filter with pH + Mineral Boost
How to Replace Filters
Unplug the unit and remove filter cover.
Remove old filter by turning it counter clockwise (Figure 1).
Install new filter by pushing and turning it clockwise. Be sure to tighten securely. HELPFUL TIP: If you find it difficult to screw on the filter, wet the O-ring on the filter housing by holding it under the cold water faucet for a few seconds.
Pivot the filter back to its vertical upright position.
Reinstall filter cover.
Press the Filter Reset Button located on the back of the AquaTru unit (Figure 2). Press and hold it for 3 to 5 seconds, or until the filter light turns off.
After installing a new filter, always discard the first two full water tanks.
Early Filter Reset
To enter Reset mode, press and hold the Filter Reset Button for 10 seconds or until the 3 filter indicators light up.
A single press of the Filter Reset Button will cause the Filter 1-2 indicator light to blink. Pressing the button again will make the Filter 3 light blink; pressing it an additional time will move the blinking light to Filter 4. Pressing Reset once again will move the light back to Filter 1-2.
Once the filter you want to reset is blinking, press and hold the Filter Reset Button for 3 to 5 seconds to reset the filter life. The light will blink rapidly for a few seconds indicating that the filter has been successfully reset.
If you decide you do not want to reset any of the filters early, leave the unit untouched for 15 seconds, and it will automatically exit out of filter reset mode.